DOP Sparge Pipes

Technical Details

 

5012PN

5102PN

Technical Specifications

Size Range 0.5 - 25.0 μm
Channel Sizes Standard: 0.5, 5.0μm
Optional: 0.5, 10.0μm
Counting Efficiency 50% at the minimum detectable size 
Flow Rate 0.1 CFM (2.83 LPM) 1.0 CFM (28.3 LPM)
Laser Source Laser Diode
Zero Count Level <1 count / 5 minutes (per JIS)
Concentration Limits 2,000,000 particles / ft³ @ 5% coincidence loss 500,000 particles / ft³ @ 5% coincidence loss
Calibration ISO 21051-4 compliant ISO 17025 Accredited
Sample Output Internally filtered to HEPA standards (>99.997% @ 0.3μm)
Vacuum Requirements Internal Vacuum Pump
Air Flow Internally Monitored and Controlled
Communication Modes 4-20mA Output
LED Indicators Power, Service
Connector 8-pin Phoenix
External Pump Switch 2-pin Phoenix dry-contact relay
Enclosure NEMA Style 316L Stainless Steel or Powder Coated Steel
Power 110 / 220 VAC, 50-60Hz or 24VDC 100W
Dimensions 10” (w) x 12” (h) x 6.9” (d) [25.4 x 30.4 x 14.9 cm]
Weight AC Model, 20 lbs (9 kg); DC Model, 19.5 lbs (8.85 kg)

Environmental Conditions

Operating 50°F to 104°F (10°C to 40°C) / 20% to 95% non-condensing
Storage 14°F to 122°F (-10°C to 50°C) / Up to 98% non-condensing

Accessories

Included Operating Manual on CD; AC or DC Power Input Connector Kit
Optional Printed Operating Manual; Data Cable; Sample Tubing; 24VDC 100W Power Adapter (DC Model) 

Get a Quote

GET A QUOTE

First Name (*)
Last Name (*)
Company Name (*)
Email (*)
Phone (*)
Address (*)
Country (*)
Primary Industry (*)
Message (*)
(*) Required Fields

Improves the testing of clean air hoods, Microbiological Safety Cabinets, isolators, and any installed HEPA filter where the mixing distance permitted is short, resulting in a poorly mixed aerosol challenge.  
The DOP Filter Test requires that the challenge aerosol is fully mixed in the system air stream by the time the challenge reaches the HEPA filter. In practice, this may be difficult to achieve.  
The Sparge Pipe Kit provides the tools to ensure good aerosol distribution at the point of injection. Correctly applied this allows challenge aerosols to be introduced as close as 1 meter from the filter and still achieve a homogeneous aerosol challenge. 
This is an extensive kit filled with sparge pipes and fittings of different lengths and hole configurations, duct tape, paper towel, silicon grease, sample and  inject  ports, to allow the assembly to suit most installation requirements.  
Once used the sparge pipes are removed from the system under test and stored in the easy to carry transport bag. 
The Sparge Pipe Kit is designed to work in conjunction with the Positive Injection Pump (PIP) to distribute aerosol at high velocity to assist mixing. 
The Sparge Pipe Kit is designed to fit our Aerosol Injection Ports allowing for easy and secure insertion.